Rod support post 10 made of stainless steel V2A for tubes and rods with Ø10 mm.

Rod carrier made of V2A stainless steel for all rods and tubes with Ø 10mm. Available as an open or side-closed (right or left) carrier. Side-closed version is used as a support and end piece at the same time. Fastening with bolts and spax screws, boreholes and screws are covered with base washers (optional). The rod is pushed in from the side and secured with a grub screw. With this support system, you can easily decorate the curtains on the floor, then attach the completely decorated curtain rod to the wall or ceiling. With the help of the extensions (optional), you can vary the distance to the wall in 50mm increments.

Round tube rod fastening system for wall mounting Post-10 1-track.

With this rod support system, you can easily decorate the floor and then attach the completely decorated rod to the wall. You can place the wall brackets on the curtain rail absolutely freely.
First attach the base plate to the wall with bolts. You can either attach the base plate and bolts with a mounting plate and Spax screws or screw them directly with a Spax screw.
Then slide the stainless steel supports (along with the tube) onto the studs and tighten the support grub screws (not too tight).
Then place the tube as desired and fix it with carrier grub screws.
You can also mount the carrier without a base plate, we only recommend mounting this on a hard surface, eg tiles, stone or hardwood.
Of course it is also possible to extend the rod carrier (optional). We also offer a 50mm extension made of stainless steel for the post carrier system. You connect the extension and the carrier with an adapter.